Sisal Pole 16 x 5 Inch M8 Beige: Choosing a Replacement Post

By Cat Tree King | Published: 2026-11-03

Category: ハウツーガイド

Replace a worn short post with the Sisal Pole 16 x 5 Inch M8 Beige. Follow these steps to check fit, confirm screw size, and swap it safely.

Quick answer

Choose the Sisal Pole 16 x 5 Inch M8 Beige when your cat tree’s original post is 16 inches long, 5 inches in diameter, and uses M8 screws at both ends. It is a direct replacement for that exact size and color.

Why exact size and screw matching matter

A replacement post must match the original in three dimensions: length, diameter, and screw size. If the length is off, the platform above may sit too high or too low; if the diameter is off, the post may not fit the base or top hole; if the screw size is wrong, it won’t secure safely. The 16 x 5 inch M8 beige pole is designed as a direct swap for Cat Tree King trees that use that specification.

When this post is the right choice—and when it isn’t

This post suits adult cats and multi-cat homes where a shorter, sturdy post is needed for scratching or as a structural support. It is not a universal replacement: if your tree uses a different length, diameter, or screw size, this pole won’t fit. Also, if the original post is longer than 16 inches, this one will leave a gap or change the tree’s height.

Step-by-step replacement process

Measure the old post: Remove the old post and measure its length and diameter with a ruler or tape. Compare to 16 inches and 5 inches. Common mistake: measuring while the post is still attached and getting an inaccurate length. Write down both measurements and keep them for comparison.
Check the screw size: Look at the screws or threaded holes on the old post and the tree. Confirm they are M8 (8 mm diameter). If you’re unsure, test-fit an M8 bolt. Common mistake: assuming all screws are the same size without checking. If the screws are not M8, this post is not the right fit.
Confirm mounting points: Ensure the old post has one screw hole at the top and one at the bottom, matching the new pole. Common mistake: overlooking a third hole or a different configuration. Count the holes on both the old post and the new one before installing.
Install the new post: Screw the new pole into the base first, then attach the upper platform. Tighten firmly but avoid over-tightening. Common mistake: cross-threading the screw by forcing it. Check stability by gently rocking the post after installation.

Product facts

Sisal Pole 16 inch x 5 inchØ - M8 (Beige): This beige sisal pole is 16 inches long, 5 inches in diameter, and has one M8 screw hole at each end. These are the critical measurements to compare with your existing post before ordering.
Sisal Pole 16 inch x 5 inchØ - M8 (Beige)
Sisal Pole 16 inch x 5 inchØ - M8 (Beige): The sisal is glued to an ABS interior for extra strength. That construction helps the post hold up to repeated scratching and weight.